Fish Hauler
When I showed up to do some work for the Feather River Hatchery yesterday morning, I was surprised when I saw this sitting in their garage. They say it stays in storage most of the time. Apparently this truck was actually used to haul fish way back when. Very cool.
Yuba River
Took a quick detour on my way home from work today. Yuba River at Highway 20. Hope I'm able to keep the ride pics coming. This bike is running pretty great but I did loose the shift lever this morning about half way to work. Rode the rest of the way in 4th gear then found the lever later today. Good & bad fortune; I swear this bike is cursed.
On the road again...
A little late night gasket scraping & early morning wrenching & this bike is back on the road. My friend Jared joined me for a quick shake-down run early this morning & it was smooooth sailin'! Unfortunately, I had to grab a back-up battery because it seems I cooked the other on our last ride. Other than that though, the Swamp Donkey is running (& charging) better than ever! I've even got the carb closer to being dialed in. One more jet size up & I think she'll be good. Hopefully the next pics will be from the road.
SWAMP DONKEY LIVES
Stay tooned for pictures. It's either not possible to post them here from my phone or I'm just too old to figure out how.
a little progress
Pulled the clutch hub/ rotor last night found exactly the scenario I've been reading about. Magnets had let loose & destroyed the stator in the process. You can see the shield over the magnets of the new rotor, hopefully eliminating this problem for ever. There is a big difference in the strength of the magnets however. The magnets on the new rotor are much weaker than the ones on the old factory part. Hopefully that won't be a problem.
Here's where it got interesting. The piece pictured in the center rotates independently in the clutch hub, but when I installed it in the new hub I couldn't get it to set in far enough & it also would not rotate at all. So I pulled it back apart & upon further inspection I found that the c-clips are totally different & that the ears on the new one were causing the whole problem. A quick swap & I was back in business. A quick fix, but How has this been over looked; & worse, what if I hadn't caught it???
for unintended purposes...
I get all excited over this stuff. I didn't have a "clutch spring compressor tool" for my sportster & I wasn't about to fork out 60 bones for one either. So I did a little digging on the interweb & found this idea. An oil filter wrench (size D). This wrench happens to be right around 3.5 inches in diameter & is a perfect fit. The only modification needed was to drill out the square hole to a 1/2 inch round. After that I found a washer & used the same nut that came off the bike to make it all work; & it works beautifully! By the way, the filter wrench I bought is plastic & showed absolutely no signs of breaking. So I just spent a whopping $6 on an otherwise over complicated & over priced tool to accomplish the same job. I love this sh#t!
guts
I opened up the primary last night & everything looked pretty normal... except for the chunks of magnet stuck to all the steel parts inside! In the 20 minutes or so that it took me to tear this thing apart, I got to see that there were a few other improvements made when they went to the 5 speed in '91. It's a damn good thing too, because 'What the hell were they thinking?' keeps going through my head. Mainly, because (unlike the 5 speeds) you have to remove the entire primary cover if you ever want to change your clutch cable. Lame. Oh well, just proves to me that everyone has some learning to do sometimes.
Subscribe to:
Posts (Atom)













